RTA4000 series digital oscilloscopes from R&S

  • Bandwidth: 200 MHz to 1 GHz
  • 10-bit ADC, 10.1” capacitive touchscreen
  •  Sample Rate: 5 Gsample/s interleaved
  • Memory Depth: up to 200 Msample
  • Includes Logic- and Protocol Analyzer, Waveform and Pattern Generator, DVM, Frequency Analysis, Mask Tests and Long Data Acquisitions.
  • FFT: Standard with 128 kpoints and spectrum analysis

The RTA4000 series digital oscilloscopes

Meet the power of ten and discover the Rohde & Schwarz RTA4000 series of digital oscilloscopes: ten bit ADC to see signals in more detail; ten times more memory with 1 Gsample standard memory depth to capture longer time periods and a 10″ capacitive touch screen for good display of the measured signals.

In the design of the RTA4000 series, signal integrity was paramount. The 10-bit A/D converter delivers four times the resolution of conventional 8-bit A/D converters. Due to the very low input noise, users can benefit from this extra vertical resolution. You get sharper waveforms with more signal details.

With traditional digital oscilloscopes you had to choose between deep memory length with the disadvantage of a slow update rate of the display. With the RTA4000 oscilloscope, however, this trade off is completely over. The RTA4000 doesn’t let you choose, but offers a fast update frequency and ultra-deep memory to take on any challenge that may arise in your application. 100 Msample memory depth is available on every channel when all channels are active. With interleave, 200 Msample are available to store even longer signal strings for more analysis results. Optionally, this can be extended to 1GSample. And at an update rate of 64,000 waveforms per second (or 700,000 waveforms per second in fast segmented memory mode).

All these waveforms are made visible at a high resolution (1280 x 800) 10.1 inch, capacitive touchscreen. In addition to the beautiful display of the signals, this also simplifies the operation.

A RTA4000 series oscilloscope is more than just an oscilloscope. It also includes a logic analyzer (16 channels), a protocol analyzer with decoding (I2C, SPI, CAN, LIN and many others), a spectrum analyzer, a waveform and pattern generator and a digital voltmeter. A large capacitive, high-resolution touchscreen and an acclaimed user interface makes it easy to use all of these tools.

By default, each RTA4000 series oscilloscope has four channels with a sampling rate of 2.5 Gsample/s per channel, with interleave to achieve a maximum speed of 5 Gsample/s with two active channels. The low noise input amplifiers have a range of 500 µV/div to 10 V/div over the entire bandwidth range. The bandwidth starts with 200 MHz models which can be upgraded to 350 MHz, 500MHz or 1GHz at a later stage.

Options

Further expansion possibilities are: logic analyzer (MSO), arbitrary waveform generator / pattern generator, serial triggering and decoding for I²C/SPI, UART/RS-232/RS-422/RS-485, CAN/LIN, Audio (I2S, LJ, RJ, TRM), MIL-STD-1553 and ARINC429, history and segmented memory, spectrum analyzer, spectrogram and power analyzer.

And of course a complete line of probes and accessories. Passive probes, active probes, logic probes, current probes, high voltage probes and near field probes.
For a complete overview I refer you to the probes and accessories page for R&S oscilloscopes.

Please contact us directly for a demonstration or quotation.

Need advice? Get in touch